Twenty-four years in the business. We make injection molds, compression molds, and blow molds. Molds are made at our wholly-owned shop in Eastern Europe. Our prices are commonly about 50% lower than comparable U.S. mold makers. All of the molds get full support from our U.S. based shop. About 70% of our work is for customers in United States. Molds are made to American standards, with standard components (DME or PCS bushings, ejection pins, standard screws, inch-sized plates and inserts, etc.).

Extensive experience with complicated release action – We have built many molds with cams/slides, unscrewing cores (on A and B sides), lifters, swing-out cores, scissor core pulls, etc.

We build class 101 to 105 molds – We work with you to provide the best value for your project. Most often we build class 101 tools, with cavities and cores made from quality tools steels and heat treated to at least 48 HRC. But depending on the production requirements, we can build tools from soft steel or aluminum.

In-house design team – Our design team is headed by the lead designer who has over 30 years of mold design experience. We work with you to make sure that the tool is to your specs and will meet all of your expectations.

Most of the molds are shipped by airfreight, so that the lead-time is not affected. We’ll quote your tool delivered to an airport near you and ready for pickup.

Contact Us Now and We Will Get Back To You Within 24 Hours

©2018 Aileron . All Rights Reserved